Multiple Primaries--Brain and CNS: How many primaries should be recorded in a patient with von Hippel Lindau disease that has a hemangioblastoma of the cerebellum in 2003 and a hemangioblastoma of the brainstem in 2007?
A tumor of the cerebellum (C716) and a tumor of the brainstem (C717) are multiple primaries because the topography codes are different at the fourth character of site.
MP/H Rules/Multiple Primaries--Bladder: The new multiple primary rule M7 states that tumors diagnosed more than three years apart are multiple primaries. Does this apply to in situ bladder tumors that occur more than three years apart and to an in situ tumor that occurs three years after an invasive tumor?
For cases diagnosed 2007 or later, use the MP/H rules in order. Rule M6 comes before rule M7.
M6 states that bladder tumors with certain histologies are a single primary. It is a single primary regardless of timing if there is any combination of:
papillary carcinoma [8050]
transitional cell carcinoma [8120-8124]
papillary transitional cell carcinoma [8130-8131]
Rule M7 applies to bladder tumors with histologies other than those listed above. If you have such a case, rule M7 applies to in-situ tumors and to an in situ three years after an invasive.
MP/H Rules/Histology--Brain and CNS: Is it generally correct that the code for PNET [9473/3] should be used to code tumors arising in the brain and spinal cord, and the code for pPNET [9364/3] should be used to code tumors arising in the bone and soft tissue? See Discussion.
The terms and definitions for "Brain" in the 2007 MP/H rules distinguish between pPNET and PNET. Is it correct even when the diagnostic terminology alone would lead to other coding, such as "PNET" used to diagnose a soft tissue mass in the chest and "neuroectodermal tumor" used to diagnose a brain mass?
Should additional rules be added to both "Brain" and "Other Sites" to enforce this distinction?
For cases diagnosed 2007 or later:
Yes. Assign code 9473/3 for tumors arising in the brain and spinal cord and assign code 9364/3 for tumors arising in the bone and soft tissue.
Clarification and reinforcement of this distinction will be added to the "Other sites" terms and definitions with the first revision to the MP/H rules.
Reporting Source: If the only patient record available for a physician office biopsy is the pathology report identified from a freestanding laboratory, is reporting source coded to 3 [Laboratory Only (hospital-affiliated or independent)] or 4 [Physicians office/Private Medical Practitioner (LMD)]? See Discussion.
A case was identified through a pathology report from a freestanding lab. The doctor who submitted the specimen left the state. His records cannot be located. Because the patient had the specimen removed at a physician's office, not at a path lab, is Type of Reporting Source field coded to the physicians office?
Reporting Source is the source that provided the best information used to abstract the case.
For this case, assign code 3 [Laboratory Only (hospital-affiliated or independent)]. Reporting source should reflect the lab where this case was identified. The MD office added nothing to the case, not even a confirmation of malignancy.
MP/H Rules/Histology--Colon: If a tubulovillous (TV) adenoma is in situ and other polyp(s) have an invasive component, does the in situ TV adenoma still have priority and should rule H18 be applied?
For cases diagnosed 2007 or later, always give precedence to coding the invasive. Rule H18 applies UNLESS the adenocarcinoma in the TV is in situ and the others are invasive. In this case, code the histology of the invasive adenocarcinoma.
This clarification will be added when the MP/H manual is revised.
Type of Multiple Tumors--Lung: Is this field coded to 40 [Multiple invasive] or 80 [Unk in situ or invasive] when only one nodule is biopsied of multiple existing nodules for a reported single lung primary? See Discussion.
The right lung has 4 tumor nodules in the upper lobe. Biopsy of one tumor is positive for moderately differentiated adenocarcinoma. No other work up performed.
Should code 40 be used because we dont know the behavior of the other nodules?
The best code to use in this case is 40 [multiple invasive]. For lung only, it is assumed that all of the tumors are the same histology and that all are invasive.
Date of Conclusive Terminology: Is there an applicable timeframe when coding this field?
There is no strict timeframe for Date of Conclusive Terminology. The diagnosis using conclusive terminology could be made any time following the diagnostic work-up.
The date of conclusive terminology is related to code 2 [ambiguous term followed by conclusive term] in the data item "Ambiguous terminology." Assign code 2 when a conclusive diagnosis is made 60 days or more after a diagnosis using ambiguous terminology. Record the date of the conclusive diagnosis in "Date of Conclusive Terminology."
CS Tumor Size/CS Site Specific Factor--Breast: How do you code the CS Tumor size and SSF6 fields for a breast cancer described as "Paget disease with underlying intraductal carcinoma (4cm x 3.2cm)"?
This answer was provided in the context of CSv1 coding guidelines. The response may not be used after your registry database has been converted to CSv2.CS Tumor Size: Assign code 040 for tumor size and code SSF6 as 050 [Invasive and in situ components present, size of entire tumor coded in CS TS]. The size of the invasive component is not stated AND proportions of in situ and invasive are not known.
Behavior--Bladder: What behavior code is used for a TURB path specimen diagnosis of "non-invasive urothelial carcinoma, no muscle found, depth of invasion cannot be assessed" when the clinician stages the case as Ta? See Discussion.
The SEER site specific coding module for bladder says, "If the only surgery performed is a TURB and if it is documented that depth of invasion cannot be measured because there is no muscle in the specimen, code the behavior as malignant and not in situ."
Assign behavior code 2 [in situ] based on the physician's stage Ta.
When no other information is available and the TNM designation is not available, use the instructions on page C-844 in Appendix C of the 2007 SEER manual as a default.